U.S. Air Force Senior Airman Dominick Ferneding, an aircraft metals technology craftsman with the 18th Equipment Maintenance Squadron, uses an oxy torch to cut a piece of metal at Kadena Air Base, Japan, Feb. 26, 2021. In oxy cutting, a torch is used to get the metal to its kindling temperature, before a stream of oxygen is focused on the metal. It’s burnt into a metal oxide, until the kerf extrudes slag. (U.S. Air Force photo by Yosselin Perla)
CAMERA
NIKON D850
LENS
24.0-70.0 mm f/2.8
APERTURE
28/10
SHUTTERSPEED
1/400
ISO
1000
No camera details available.
This photograph is considered public domain and has been cleared for release. If you would like to republish please give the photographer appropriate credit. Further, any commercial or non-commercial use of this photograph or any other DoD image must be made in compliance with guidance found at https://www.dimoc.mil/resources/limitations, which pertains to intellectual property restrictions (e.g., copyright and trademark, including the use of official emblems, insignia, names and slogans), warnings regarding use of images of identifiable personnel, appearance of endorsement, and related matters.